broadcom 5722 NIC not installed on Ubuntu Server, although driver present
- by Bastien
Hello, I just installed Ubuntu Server 10.04 LTS, running kernel 2.6.32-24-server, on a brand new Dell T110 server, supposedly fully compatible with Ubuntu Server.
I have two NICs: one ONBOARD, the other additional on PCI.
both of them are Broadcom netXtreme 5572.
on the first boot of the system, I could see both cards as eth0 and eth1 (with ifconfig)
I configured eth0 as static IP (as planned), and did not configure eth1.
after rebooting, one of the two NICs "disappeared": it does not appear in ifconfig at all.
the one that disappeared is the ONBOARD one. I investigated a bit and found the following things:
the card is SEEN, but not "installed", it appears as "UNCLAIMED" in lshw:
*-network UNCLAIMED
description: Ethernet controller
product: NetXtreme BCM5722 Gigabit Ethernet PCI Express
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:04:00.0
version: 00
width: 64 bits
clock: 33MHz
capabilities: pm vpd msi pciexpress cap_list
configuration: latency=0
resources: memory:df9f0000-df9fffff
*-network
description: Ethernet interface
product: NetXtreme BCM5722 Gigabit Ethernet PCI Express
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:05:00.0
logical name: eth0
version: 00
serial: 00:10:18:60:23:64
size: 100MB/s
capacity: 1GB/s
width: 64 bits
clock: 33MHz
capabilities: pm vpd msi pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=tg3 driverversion=3.102 duplex=full firmware=5722-v3.09 ip=10.129.167.25 latency=0 link=yes multicast=yes port=twisted pair speed=100MB/s
resources: irq:35 memory:dfaf0000-dfafffff
so I checked my dmesg and found a few strange lines, showing, there actually is a problem bringing up this card:
[ 3.737506] tg3: Could not obtain valid ethernet address, aborting.
[ 3.737527] tg3 0000:04:00.0: PCI INT A disabled
[ 3.737535] tg3: probe of 0000:04:00.0 failed with error -22
[ 3.737553] alloc irq_desc for 17 on node -1
[ 3.737555] alloc kstat_irqs on node -1
[ 3.737560] tg3 0000:05:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 3.737566] tg3 0000:05:00.0: setting latency timer to 64
[ 3.793529] eth0: Tigon3 [partno(BCM95722A2202G) rev a200] (PCI Express) MAC address 00:10:18:60:23:64
[ 3.793532] eth0: attached PHY is 5722/5756 (10/100/1000Base-T Ethernet) (WireSpeed[1])
[ 3.793534] eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1]
[ 3.793536] eth0: dma_rwctrl[76180000] dma_mask[64-bit]
that actually shows that one NIC is recognized, the other is not.
I researched a bit more, with lspci -v:
04:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5722 Gigabit Ethernet PCI Express
Subsystem: Broadcom Corporation NetXtreme BCM5722 Gigabit Ethernet PCI Express
Flags: fast devsel, IRQ 16
Memory at df9f0000 (64-bit, non-prefetchable) [size=64K]
Capabilities: [48] Power Management version 3
Capabilities: [50] Vital Product Data <?>
Capabilities: [58] Vendor Specific Information <?>
Capabilities: [e8] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable-
Capabilities: [d0] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting <?>
Capabilities: [13c] Virtual Channel <?>
Capabilities: [160] Device Serial Number 00-00-00-fe-ff-00-00-00
Kernel modules: tg3
05:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5722 Gigabit Ethernet PCI Express
Subsystem: Broadcom Corporation NetXtreme BCM5722 Gigabit Ethernet PCI Express
Flags: bus master, fast devsel, latency 0, IRQ 35
Memory at dfaf0000 (64-bit, non-prefetchable) [size=64K]
Expansion ROM at <ignored> [disabled]
Capabilities: [48] Power Management version 3
Capabilities: [50] Vital Product Data <?>
Capabilities: [58] Vendor Specific Information <?>
Capabilities: [e8] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable+
Capabilities: [d0] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting <?>
Capabilities: [13c] Virtual Channel <?>
Capabilities: [160] Device Serial Number 64-23-60-fe-ff-18-10-00
Capabilities: [16c] Power Budgeting <?>
Kernel driver in use: tg3
Kernel modules: tg3
here I could see that the MAC address is 00-00-00-FE-FF-00-00-00, which, according to some forum posts on several websites, could be an issue.
I've researched everything I could on the net, and found out several people having slightly comparable issues, but they usually involve different HW, and do not provide a proper explanation / solution... I would appreciate if anyone around here has some info to share !
thanks
