Search Results

Search found 2726 results on 110 pages for 'processor'.

Page 19/110 | < Previous Page | 15 16 17 18 19 20 21 22 23 24 25 26  | Next Page >

  • NSClient++ FAIL on Windows 2008 R2 -- PDHCollector.cpp(215) Failed to query performance counters

    - by John DaCosta
    I am attempting to monitor windows server 2008 r2 x64 Enterprise with Nagios. When I test/install the nsclientI get the following error: PDHCollector.cpp(215) Failed to query performance counters: \Processor(_total)\% Processor Time: PdhGetFormattedCounterValue failed: A counter with a negative denominator value was detected. (800007D6) Has anyone else encountered the same issue and / or resolved it, found a work around?

    Read the article

  • Virtual PC on Windows 7 - Hardware-assisted virtualization is disabled

    - by DLux
    I am running a Lenovo Thinkpad T61 with an Intel Core 2 Duo T7300 processor. When I run Virtual PC in Windows 7, I get the following error: Unable to start Windows Virtual PC because hardware-assisted virtualization is disabled. When running the Hardware-Assisted Virtualization Detection Tool from Microsoft says: Hardware-assited virtualization is not enabled on this computer. Now, in the BIOS, I do have virtualization enabled and according to Intel this processor supports Intel-VT. What am I missing here?

    Read the article

  • Core i5 Turboboost/C states Freezing computer

    - by Aaron Smith
    I'm not sure which, but I just had a heck of a time getting my computer to boot up and not freeze. It would run until it finished booting windows, then everything would freeze. This happened until I turned off turboboost and all the c states on the processor. What could be causing this? Is the processor going bad?

    Read the article

  • Snow Leopard on Core Duo

    - by Brendan Foote
    The first run of MacBook Pros have Core Duo processors, whereas all the ones after that have Core 2 Duos. Apple says Snow Leopard only requires an Intel processor, but will a first-gen MacBook Pro get enough of the improvements to be worth upgrading? This is similar to the question about Snow Leopard on an old iBook, but it differs because this processor is supported by Apple, but seems counter to the 64-bit theme of the upgrade.

    Read the article

  • intel dg31pr heat issues

    - by user17077
    Hi there, I have got Intel 8400 processor installed on a DG31PR board. My board gets hot quite quickly and the temperature hovers around 50-65 C at normal load. I have got a good cooling system but I wonder if its a problem in my mobo. Can you guys kindly suggest what to do? My processor runs fine and stands at 30-32 C. Thanks. Regards, Adnan

    Read the article

  • Will Windows 7 work at all on my old toshiba [closed]

    - by andrew
    Windows 7 requires the following specifications: 1 gigahertz (GHz) or faster 32-bit (x86) or 64-bit (x64) processor 1 gigabyte (GB) RAM (32-bit) or 2 GB RAM (64-bit) 16 GB available hard disk space (32-bit) or 20 GB (64-bit) DirectX 9 graphics device with WDDM 1.0 or higher driver Will it work at all on my old toshiba Satellite A100 PSAA8C-SK400E Intel® Core™ Solo processor T1350 (1.86GHz, 533MHz FSB, L1 Cache 32KB/32KB, L2 Cache 2MB) Standard Memory: 2x512 MB DDR2 Intel® Graphics Media Accelerator 950 with 8MB-128MB. The main problem I can see is that the graphics is not up to it.

    Read the article

  • how to get CPU utilization in zabbix from Windows server?

    - by kusoksna
    I'm trying to monitor CPU utilization of windows 7 32bit PC (C2D E8400) using zabbix. I tried both "perf_counter[\Processor Information(_Total)\% Processor Time]" and "system.cpu.util[,system,avg5]". After some time status of these items reverted itself to "Unsupported". Is this problem on agent side, or at server? How to fix it? Ideally I want to see percentages load per each core. UPD: topic and description updated.

    Read the article

  • Shows error message "ialmrnt 5 display driver stooped working".

    - by user68705
    when ever i play movie with high resolution(720hz) My Destop PC shows a black screen and after a while shows message "ialmrnt 5 display driver stooped working". and i am having the following configuration 1GB RAM DDR1 windows xp OS processor- Intel Pentium 4 Processor Srm-Motherboard Graphics Driver Product Detected -Intel® 845G Current Driver Installed-6.14.10.3889 Intel Chipset Software Installation Utility (Chipset INF) - Current Version Installed 9.1.0.1012 kindly help me to fix this problem

    Read the article

  • Does it make sense to install an SSD into a 3rd generation MacBook?

    - by Ivan Krechetov
    I've heard that, to really benefit from a solid-state drive, one needs a motherboard fast enough. Do you think it's worth to install an SSD into this laptop? Model Name: MacBook Model Identifier: MacBook3,1 Processor Name: Intel Core 2 Duo Processor Speed: 2.2 GHz Number Of Processors: 1 Total Number Of Cores: 2 L2 Cache: 4 MB Memory: 4 GB Bus Speed: 800 MHz Boot ROM Version: MB31.008E.B02

    Read the article

  • Compatiblity of 64 bit systems

    - by Bill
    I am running Windows Vista home premium 32bit on an Intel core2 duo E7300,which I believe is actually a processor capable of running 64bit.I also run Adobe photoshop CS5 which i believe could utilise the 64 bit processor and more ram.Could I change my operating system to 64bit and would I gain anything from doing so.

    Read the article

  • PC monitors shut off and system hangs while playing 3D games, but sound continues - Diagnosis?

    - by Jon Schneider
    Two days ago, I started running into a problem with my Windows PC: The PC's two connected monitors simultaneously lose signal and go black (as though the PC had been powered off). The keyboard's Numlock, Capslock, and Scroll Lights will become "stuck" in their current positions, as though the PC is hung. (For example, the Numlock light on the keyboard remains lit regardless of me pressing the Numlock key repeatedly.) No keyboard input does anything. (Ctrl+Alt+Del, Ctrl+Shift+Esc, Ctrl+C, etc.) However -- Whatever sound/music the PC was playing continues to play, and the PC's fans continue running, so the PC hasn't powered itself off or rebooted itself. Opening up the case, the graphics card is pretty hot to the touch. I had this happen 3 times in one evening. In all cases, I was playing a game with 3D graphics when the problem occurred (Torchlight, Minecraft, Magic: The Gathering 2012, Avadon: The Black Fortress demo). I have yet to have the problem happen when I'm not playing a game. This system has been running stable for about 2.5 years prior to this. I didn't make any changes to the system prior to the problem starting to occur. System specs: OS: Windows 7 64-bit Processor: Intel Core 2 Duo E7200 Wolfdale 2.53GHz Video Card: XFX GeForce 9800 GT 512 MB Motherboard: Foxconn P45A-S LGA 775 Intel ATX RAM: Corsair 4 GB (2x 2GB) DDR2-800 (PC2 6400) Full specs: New PC 2008 Troubleshooting tried so far (the problem occurred again after taking each of these steps, one at a time): Updated the video drivers with the latest drivers from NVidia's site. Opened up the case and cleaned out the video card and processor fans (both were pretty dirty). Installed and ran temperature monitor software. The processor idles at about 50 degrees C, and goes up to about 63 degrees C while playing a game (seems on the warm side, but not excessively so?). The software wasn't able to report the temperature of the GPU -- not sure this particular GPU supports software temperature readout? My initial diagnosis is that maybe the GPU is on its last legs (given that it seems to be running pretty hot, and the problem only occurs while playing 3D games). Does this seem likely? Or is it likely that this problem is caused by the processor, RAM, or motherboard? Or could this be a software issue of some kind? Thanks for any advice!

    Read the article

  • Changing my PC's motherboard

    - by Shyam
    I have a Asus A7N266 motherboard currently with a Athlon XP 1.8GHz processor that I assembled in 2002. The Video RAM for this is just 32 MB. I would like to upgrade my motherboard and retain the Processor. Is that advisable? If so, could you also suggest a good motherboard that has a better VGA capability?

    Read the article

  • Why is the server performance so poor? What can be done to improve the speed of the server?

    - by fslsyed
    Very slow processing using Windows Server2008 R2 Standard with Service Pack One. Situation: Read a text file using the text data to populate a series of MS Sql tables. The converted data is used to generate monthly PDF invoice files; the PDF files are saved directly to the hard drive. The application is multi-threading with one thread used for the text conversion and three threads for PDF invoice generation. The text conversion is occurring concurrently with the invoice generation. Application Software: C# using Microsoft Visual Studio 2010 Ultimate. Crystal Report Writer 2011 with runtime 13_0_3 64 bit version. Targeted platform is x64; also tested as x86, and Any CPU with similar results. Microsoft .NET Framework 4.0. Microsoft Sql 2008 Issue: The software is running very slowly. The conversion of the text file is approximately six hundred fifty records per second and generation of the PDF files is approximately twelve invoices per minute. The text file to be converted is six hundred Meg with seven thousand invoices to be generated. The software was installed on three different machines from the same distribution files. The same text file was converted on each machine. The user executing the application was an administrator on each machine. The only variances were the machine and operating system. The configurations are as follows: Server: Operating System: Windows Server2008 R2 Standard 64-bit (6.1, Build7601) SP1 Service Pack: System Manufacturer: IBM System Model: System x3550 M3-[7944AC1]- BIOS: Default System BIOS Processor: Intel® Xeon® CPU E5620@ 2.4GHz (16 CPUs) Memory: 16384MB Notebook: Operating System: Windows 7 Home Premium Standard 64-bit (6.1, Build7601) System Manufacturer: Hewlett-Packard System Model: HP Pavilion dv7 Notebook PC BIOS: Default System BIOS Processor: AMD Phenom II N640 Dual-Core Processor 2.9GHz (2 CPUs) Memory: 6144MB Desktop: Operating System: Windows 7 Professional 64-bit (6.1, Build7601) SP1 System Manufacturer: Dell Inc. System Model: OptiPlex 960 BIOS: Phoenix ROM BIOS PLUS Version 1.10 A11 Processor: Intel Core™2 Quad CPU Q9650 @3.00GHZ (4 CPUs) Memory: 16384MB Processing results per machine: The applications were executed seven times with the averages being displayed below. Machine Text Records Invoices Generated Converted Per Minute Per Minute Server (1) 650 12 Notebook 980 17 Desktop 2,100 45 (1) The server is dedicated to execution of this application; no additional applications are being executed. Question: Why is the server performance so poor? What can be done to improve the speed of the server?

    Read the article

  • Can I install an x86 version of XP on an acer aspire one

    - by Liam
    I have bought an acer aspire one which has the intel atom processor running linux and am having difficulty getting a 3G USB modem (huwaei e220) working with it. I have spent a significant amount of time trying to get this working but as the modem is not supported on Linux I have now decided to give in and install xp. Is there a specific version of xp that I need for this processor? or can I install the standard x86 version

    Read the article

  • Intel hd or Mobility Radeon?

    - by Absolute0
    I have decided to get a new Dell Studio 15 laptop. They have an option of adding a "ATI Mobility Radeon™ HD 4570, 512MB" card for an extra $100 instead of the included "Intel HD Graphics" card. How do the two compare? The laptop comes with an Intel Core i3 processor, maybe the Intel graphics card would be more compatible with the processor since they're made by the same manufacturer? Thanks in advance!

    Read the article

  • CPU fan making noise. plz suggest

    - by user32185
    CPU fan is making noise ...i figured out reasons: Cable coming out of fan is vibrating ... And may be also CPU fan is loose causing vibration... suggest options... i cleaned the fan ...but found that there is no heatsink compound /paste between processor and the fan..is it ok . My processor is p4 2.4 ghz motherboard intel 845 gvsr

    Read the article

  • Where can i get the motherboard cd's

    - by Velmrugan
    Hi, Can you please tell me where can i get the mother board softwares for my intel celeron processor. I need Audio driver, Graphics & windows installer for my Intel celeron processor. Where can i download all these softwares, freely. I searched in Intel homepage but i cant find what and all to download, So please can u tell me briefly how to download these files. Regards, Velmurugan

    Read the article

< Previous Page | 15 16 17 18 19 20 21 22 23 24 25 26  | Next Page >