Broadcom HT1100 SATA controller not working properly with 1TB drives
- by Jeff C
I've been using RHEL distro's for several years and always managed to find the answers until now. I know this is more of a hardware issue, but I've been working on this for over a week and trust Linux and the IT community to help more then HP.
I have CentOS 6.3 installed on an HP ProLiant DL145 G3 server with the BroadCom HT1100 IO controller and ServerWorks SATA Controller MMIO BIOS v3.0.0015.6 Firmware. This controller does not support large drives fully.
Here's what I've tried and the results;
Stock setup - Freezes on the ServerWorks POST screen. Can't even enter CMOS without disconnecting the drives.
If I simply disconnect the SATA cables before it gets to the ServerWorks screen and reconnect afterwards I can boot from a CD, USB, PXE fine. However fiddling with cables at ever boot isn't practical.
If I enter the BIOS config I can set it to not try booting the drives but leave the controller enabled. This lets me boot normally but the drives are not visible in the OS (live CDs or USB installed).
I used method #2 to install and update CentOS. I have the /boot partition on a USB drive (everything else is on the SATA drives in software RAID1) hoping that would work around the issue but I get this
Kernel panic - not syncing:Attempted to kill init!
Pid: 1, comm: init Not tainted 2.6.32-279.9.1.el6.x86_6 #1
Call Trace:
[<ffffffff814fd6ba>] ? panic+0xa0/0x168
[<ffffffff81070c22>] ? do_exit+0x862/0x870
[<ffffffff8117cdb5>] ? fput+0x25/0x30
[<ffffffff81070c88>] ? do_group_exit+0x58/0xd0
[<ffffffff81070d17>] ? sys_exit_group+0x17/0x20
[<ffffffff8100b0f2>] ? system_call_fastpath+0x16/0x1b
panic occured, switching back to text console
I'm sure it should be possible to talk to the drives without the BIOS boot check since the BIOS doesn't see them in method #2 either, their disconnected when it checks, but Linux sees them fine. If anyone could help figure out how I would greatly appreciate it!
The other possible option I've come across is a complex firmware update. Tyan has a few boards on their website with the HT1100 and a ServerWorks v3.0.0015.7 update which says "adds support for TB drives" in the release notes. If someone could help me get the Tyan SATA firmware into the HP ROM file so I could just reflash that would also be very much appreciated.
Thanks for any help you guys can offer!
