Search Results

Search found 12282 results on 492 pages for 'memory deallocation'.

Page 258/492 | < Previous Page | 254 255 256 257 258 259 260 261 262 263 264 265  | Next Page >

  • Low FPS in some games, but hardware not fully used

    - by Mario De Schaepmeester
    I just did a little funny experiment in the game/sim "Train Simulator 2013". I normally have good FPS in it (around 30) at full settings. What I did was make a really, really long train so that the calculations the sim needed to make were enormous (the sim is quite realistic, it takes all things into account like speed/acceleration, G-forces, comfort levels, possible wheel slip and many more, and most of those things on each carriage seperately). This resulted in only 14FPS as reported by the game, but it felt more like 8FPS or so. I have a Logitech G15 keyboard which has an LCD, and it allows me to monitor CPU/RAM and video card load on it. The strange thing is, all CPU cores were busy, but the total load was only about 60% maximum at all times. The video card was only on 30% load (possibly an important note, the memory was full, which is however not unusual for the game in question). The RAM had plenty of room and there weren't many operations as it didn't grow or shrink much. I just have the feeling that the game would run smoother if it used more of my hardware power. Why is it not doing so? I had the same in another game, The Elder Scrolls: Morrowind when using more than 100 mods (that all use scripting) and a few high res texture mods, + a full-on graphics improvement program. The engine is very old (2003), and so I thought this might be the cause (not being optimised for multithreading). I had thought of possible causes, like: The operating system doesn't let the games use all the resources. It doesn't make use of multi-threading appropriately. To eliminate the former, I tried a CPU stress tool and that got 100% CPU juice as I let it run, so the OS is not the problem. I gave its thread the "higher" priority though. My actual question In both games, I did things the engine was not really built to do or support. Can those games' framerate be limited cause of their own engine not being able to cope? What is the real reason and more importantly, can I help it? And in any case, could something actually be wrong with my hardware? It's all reasonably new, a couple of months, and I (almost) never experience any other trouble. Modern and much more demanding games work absolutely fine. Specs CPU: AMD Phenom II 965 X4 @ 3.4gHz RAM: 8GB of DDR3 RAM Video: MSI GTX560 (nVidia chip) with 1GB of GDDR5 memory OS: Windows 7 Ultimate 64 bit Nothing overclocked.

    Read the article

  • how to set up a git repository which can be accessed by network in ubuntu 12.10

    - by hguser
    Now we want to set up a private git repository in the ubuntu 12.10,then other developments can access it through the local network. Now I just can create a repository use git init,for example: cd myproject git init Which will create .git directory,but I do not know how to access it thougth network like: git://192.168.1.1/myproject/.git Any idea? BTW,I have tried: git init --bare which will give me a error: git add error : "fatal : malloc, out of memory"

    Read the article

  • looking for the best power supply-- building computer--- [closed]

    - by fello
    What would be an appropriate power supply and form factor for those specifications below? CPU -Intel Core i7-950 Bloomfield 3.06GH Motherboard -- ASRock X58 Extreme 3 LGA ATX Hard drive-- Seagate Barracuda 7200.11 ST31500341AS 1.5TB 7200 RPM SATA 3.0Gb/s 3.5" Memory-- Kingston HyperX 8GB (2 x 4GB) 240-Pin DDR3 SDRAM DDR3 1600 (PC3 12800) Processor---Intel Core i7-950 Bloomfield 3.06GHz LGA 1366 130W Quad-Core

    Read the article

  • Resource consumption of FreeBSD's jails

    - by Juan Francisco Cantero Hurtado
    Just for curiosity. An example machine: an dedicated amd64 server with the last stable version of FreeBSD and UFS for the partitions. How much resources consume FreeBSD for each empty jail? I mean, I don't want know what is the resource consumption of a jailed server or whatever, just the overhead of each jail. I'm especially interested on CPU, memory and IO. For a few jails the overhead is negligible but imagine a server with 100 jails.

    Read the article

  • Are these tools a gimmick?

    - by dotnetdev
    Hi, Are tools which analyse which enable you to use all your CPU cores (eg: GBP.htm"http://www2.ashampoo.com/webcache/html/1/product_2_0061_GBP.htm) and also tools which help you to regain memory (can't think of any just yet but seen plenty) a gimmick? Do these tools really work? Thanks

    Read the article

  • How to optimally configure memcache running on 16 cores 144G ram server?

    - by Ivko Maksimovic
    Memcache is the only important app running on the server Server has 16 cores and 144G RAM Memcache is given 135G Memcache runs at 32 threads Gigabit network, test shows at least 300Mbit/s availability on network port 600 connections 3000 requests per second Say that memcache (memory) usage is at 50% - it's definitely not full As we increase number of requests towards server, requests slow down (from 8ms to 100ms per request) but server load remains 0.00. We suspect this can be solved by adjusting configuration but we don't understand many of the configuration parameters (besides, maybe, the number of threads). Any ideas?

    Read the article

  • xp stop error 50 page fault in non paged area

    - by Tony
    I have a laptop that fails to boot with the BSOD error: "page_fault_in_non_paged_area" STOP: 0x00000050 (0xEC6B738D, 0x00000000, 0x8649308C, 0x00000000) The laptop has 2 memory DIMMs. I removed each DIMM one at a time and the error remained with just one DIMM installed. I have run spinrite 6.0 on the hard drive no errors found. Booted to recovery mode and ran CHKDSK /R, it found and fixed errors but still gets the stop error. Any other suggestions to try?

    Read the article

  • Are there any USB flash drives or SD cards which use RAID or redundant storage for additional reliability?

    - by Luke Dennis
    I'm looking to get a fault-tolerant USB flash drive, which saves data to multiple independent locations, whether using RAID or some other means to back up data. Has a product like this ever been created, or are my only options to hack something together? (By the way: I'm aware that RAID doesn't prevent data corruption from software or the file system. I'm just looking for something that can handle one of the memory sticks going dead.)

    Read the article

  • Excel freezes when copying / cutting to paste elsewhere

    - by Barry
    When cutting/copying some cells to paste them into another sheet/page, sometimes Excel freezes/locks up and fades out. At the top toolbar it says in brackets "not responding". Eventually, I must click 'X' to close the program. It offers to wait for the program to respond, but never does – it just does nothing until I finally close it, where it offers to recover files etc. Is there an issue with memory here? What can I do to stop it locking up?

    Read the article

  • Rolling Apache2 log files

    - by Andrew B
    I'm using a Collabnet svn distribution on linux, and the log files are configured through the standard apache httpd.conf. It's been a while since I dealt directly with apache, but my memory and google seem to indicate that the only way to rotate apache log files is outside of apache, using a periodic script. Is there some convenient way I'm missing to rotate these?

    Read the article

  • Is it safe to run two instances of svnserve on one repository, or only one?

    - by fredden
    We've two nodes running heartbeat/drbd, and one of the services we're using is subversion. What I want to know is: is it safe to run svnserve on both nodes all the time, or should it only run on the active node? Does svnserve use file-level locking, or is it all in memory? What are the implications of running svnserve without its repositories accessible? Please let me know if this isn't clear, and I'll try my best to rephrase/clarify. :)

    Read the article

  • Xen command xl doesn't create a vm but xend/xm does

    - by ineff
    I'm a newbie to Xen, and I've recently installed Xen 4.2 by sources on my system. I've found a strange thing I've a VM when I start it via the command "xm create machine.cfg" all work fine, but if I use "xl create machine.cfg" it gives me the following error xc: error: panic: xc_dom_core.c:442: xc_dom_alloc_segment: segment ramdisk too large (0x4ba 0x2000 - 0x1bd9 pages): Out of memory libxl: error: libxl_dom.c:208:libxl__build_pv xc_dom_build_image failed: Invalid argument cannot (re-)build domain: -3 xenconsole: Could not read tty from store: No such file or directory What could be the problem? Any idea?

    Read the article

  • What is a good lightweight webradio program

    - by Robert Vukovic
    I am currently using Screamer Radio but it is a little bit buggy. It freezes a lot if internet connection is bad and can not continue if there are interruptions in the internet connection. I am not interested in some full sized MP3/media player, just a simple (with low memory footprint) application that can play streaming internet radio stations.

    Read the article

  • Ubuntu 64-bit vs 32-bit

    - by tukushan
    Is it worth installing the Ubuntu 9.10 64-bit version over the 32-bit x86 version? I will get the ability to address more than 4 GB of memory, but other than that, how does the 64-bit version fare in terms of performance and stability?

    Read the article

  • A Versatile Physical Server

    - by Paul
    How does one judge potential memory and processor needs for linux web servers? Specifically, given: A Debian or Ubuntu OS Running a web server (apache2), and A database (MySQL), and A DNS server (bind), and Being used by up to 100 concurrent users, at some points each downloading high-resolution (0.5 to 1 MB) images via a web app. How much should one budget in terms of RAM, type of processor(s), and number of cores? Thanks!

    Read the article

  • iSCSI NAS supporting VMware Esxi 5.1 servers in a software development environment

    - by BigTFromAZ
    I would like to build (or purchase) the smallest, quietest most energy efficient servers that I can for a low demand environment. These would only have a small disk for guest swap files, a CPU (XEON preferred), 32 Gb of memory and minimal graphics. The virtual machines need to be up but demand will be quite low. Any thought on case, format processors, fans, motherboard, et al? Small, quiet and lots of RAM are the operative words here.

    Read the article

  • Excel 2007 charts disappearing

    - by AppsByAaron
    I have an Excel 2007 file with macros and VB (.xlsm) and one of the worksheets has charts. When I open the file those charts are shown. However when I CTRL+Scroll to zoom in the charts vanish. I need to be able to see the charts so I can move/resize them. Any help is appreciated. Running XP Pro with latest SP Over 3 GB memory Office 2007 Pro

    Read the article

< Previous Page | 254 255 256 257 258 259 260 261 262 263 264 265  | Next Page >