Hello, I have 1 master and 2 slaves. I am using MySQL 5.1.42 on all servers. I am attempting to use mk-table-checksum to verify that their data is in sync, but I am getting unexpected results on one of the slaves. First, I generate the checksums on the master like this: mk-table-checksum h=localhost --databases MYDB --tables {$table_list} --replicate=MYDB.mk_checksum --chunk-size=10M My understanding is that this runs the checksum queries on the master which then propagate via normal replication to the slaves. So, no locking is needed because the slaves will be at the same logical point in time when they run the checksum queries on themselves. Is this correct? Next, to verify that the checksums match, I run this on the master: mk-table-checksum --databases MYDB --replicate=IRC.mk_checksum --replicate-check 1 h=localhost,u=maatkit,p=xxxx If there are any differences, I repair the slaves like this: mk-table-sync --execute --verbose --replicate IRC.mk_checksum h=localhost,u=maatkit,p=xxxx After doing all of this, I repaired both slaves with mk-table-sync. However, everytime I run this sequence (after everything has already been repaired), one slave is perfectly in sync but one slave always has a few tables out of sync. I am 99.999% sure that the data on the slaves matches, since I repaired everything and the tables were not even updated on the master between runs of the checksum script. What would cause a few tables to always show out of sync on only one of the slaves? I am stuck. Here is the output: Differences on h=x.x.x.x,p=...,u=maatkit DB TBL CHUNK CNT_DIFF CRC_DIFF BOUNDARIES IRC product 10 0 1 product_id = 147377 AND product_id < 162085 IRC post_order_survey 0 0 1 1=1 IRC mk_heartbeat 0 0 1 1=1 IRC mailing_list 0 0 1 1=1 IRC honey_pot_log 0 0 1 1=1 IRC product 12 0 1 product_id = 176793 AND product_id < 191501 IRC product 18 0 1 product_id = 265041 IRC orders 26 0 1 order_id = 694472 IRC orders_product 6 0 1 op_id = 935375