Hello, we just have upgraded the firmware of a dell 6224 power connect switch and it won't reload. These are the symptons: - I power up the switch having the serial cable connected to it and the switch outputs nothing. The configuration of the serial console is fine: 9600 bds, etc... In fact, before the upgrade, I was connected to the switch through the very same cable. - Reseting the switch with its reset pinhole does not reset the switch: the power and fan lights powers off while I keep pressed the pinhole, but the switch itself does not resets. - When I connect an UTP cable to one of the switches port, the green lights don't flash, but ''mii-tool eth0'' in my laptop shows there is link!!

The only thing I see in the output, different from other upgrades I've done, is this line at the end:

Erasing Boot Flash.....^^^^Done.

Any help or idea will be more than welcome!!

Thanks!!

console#show version

Image Descriptions

image1 : image2 :

Images currently available on Flash

-------------------------------------------------------------------- unit image1 image2

current-active next-active

1      <none>     3.0.0.8             image2             image2 

console#boot system image2 Activating image image2 ..

console#update bootcode Update bootcode and reset (Y/N)?

Updating boot code ... Extracting boot code from image... Erasing Boot Flash.....^^^^Done.