mpIO vs MC/S Vs Link Agg Groups

Posted by Xiuhtecuhtli on Super User See other posts from Super User or by Xiuhtecuhtli
Published on 2010-06-08T16:42:12Z Indexed on 2010/06/08 16:42 UTC
Read the original article Hit count: 392

Filed under:

iscsi

What are the main Pro/Con to mpio, mcs, & lAG for a iscsi Session in windows.

From What i have been reading LAG is this best for Preformance while MCS is the least buggy and fault tolerant, while mpio is more of a hybrid.

Related posts about iscsi

Removing an iSCSI Target - iSCSI initiator 2.0 on Windows Server 2003 R2

as seen on Server Fault - Search for 'Server Fault'
For the life of me I cannot figure out how to remove an iSCSI target (Dell Equallogic SAN) from a Windows Server 2003 box. The volume shows up in Windows as drive letter Y:\ Using the iSCSI initiator, I can remove the Target Portal, but cannot remove the Target itself. Can someone give me some… >>> More
AIX: iscsi volumes disappear after reboot

as seen on Server Fault - Search for 'Server Fault'
We have an IBM P505 AIX box, with two internal disks and a defined iSCSI volume. The iSCSI volume is defined in it's own volume group, and is connected to an IBM iSCSI DS3300 disk array via the secondary onboard ethernet port (ie, we're not using a dedicated HBA, we're using the second onboard ethernet… >>> More
How to connect SAN from CentOS through two iSCSI Targets

as seen on Server Fault - Search for 'Server Fault'
I had asked the similar question before. This time I want to use subnet for two iSCSI Targets, hence I start a new question. I have an old Promise VTrak M500i SAN Server. It comes with 2 iSCSI ports. I want to connect to two LUNs on the SAN server through two separate Targets from CentOS 5.7 64bits… >>> More
Can single ESXi host make use of two separete iSCSI box?

as seen on Server Fault - Search for 'Server Fault'
Hi! I have problem with using multiply iSCSI targets with single ESXi host (in my case they are two FreeNAS hosts, but I suspect that this problem will occur with any two iSCSI box of that same type/model). If I configure two FreeNAS hosts as iSCSI targets (say iSCSI A and iSCSI B), then I can use… >>> More
Problems with 2 ISCSI connections esxi 3.5

as seen on Server Fault - Search for 'Server Fault'
I am running a dell poweredge 1950 with 4 nic cards. 1 is bonded to SAN #1 on 192.168.90.xx. The second SAN is on a separate network - 192.168.7.xx The network adapter can view the ip range of the san and the NIC can be pinged from 192.168.7.xx range. vswitch1 and vswitch2 are configured identically… >>> More

Developer IT

mpIO vs MC/S Vs Link Agg Groups - Developer IT

mpIO vs MC/S Vs Link Agg Groups

iscsi

Related posts about iscsi

Removing an iSCSI Target - iSCSI initiator 2.0 on Windows Server 2003 R2

AIX: iscsi volumes disappear after reboot

How to connect SAN from CentOS through two iSCSI Targets

Can single ESXi host make use of two separete iSCSI box?

Problems with 2 ISCSI connections esxi 3.5

Categories cloud