Linksys WAP54G v3.1 no access, power and link LED solid
- by user142113
I'm managing the Network of a small enterprise. A Linksys WAP54G v3.1 used to provide the WiFi network.
I was called, because the device did not provide a WiFi network anymore. I first of all tried to ping the device via LAN, but there was no reaction.
I've frequently reconnected the AP to the mains and always the POWER and the LINK LED keep solid, even if no network cable is connected.
What I've done yet:
Reset as documented: Pressed the RESET button for 10 seconds. After that I have tried to access the AP with a direct cable connection to my computer, that I've set to a static ip of 192.168.1.240, but i got no ping response on the default IP 192.168.1.245. Furthermore ipconfig reports "media disconnected".
More complex reset method as described here http://bruceshankle.blogspot.de/2005/12/how-to-reset-linksys-wap54g.html as well had no effect. also tried to ping 192.168.1.1 without success
Tried this method: http://www.daniweb.com/hardware-and-software/networking/threads/142437/linksys-wireless-access-point-problem#post680245 but there was no ping response when powering up. As well the tftp transfer timed out
Finally tried to short pin 15 and 16 of the flash chip on the bottom side of the AP mainboard while booting to provoke a Checksum error. This should lead to the possibility to upload a firmware with tftp, as the AP stops booting and waits for a tftp connection on 192.168.1.1. But I've had no success. As well i've put pin 15 and 16 to ground while booting, also without an effect.
After all that I still can't ping the AP, ipconfig still tells me "media disconnected". The POWER and LINK LED are solid.
I would appreciate your answers
