I installed Kismet on my Ubuntu 10.04 machine as apt-get install kismet every thing seems to work fine.

but when I launch it I see following error

kismet

Launching kismet_server: //usr/bin/kismet_server
Suid priv-dropping disabled.  This may not be secure.
No specific sources given to be enabled, all will be enabled.
Non-RFMon VAPs will be destroyed on multi-vap interfaces (ie, madwifi-ng)
Enabling channel hopping.
Enabling channel splitting.
NOTICE: Disabling channel hopping, no enabled sources are able to
change channel.
Source 0 (addme): Opening none source interface none...
FATAL: Please configure at least one packet source.  Kismet will not
function if no packet sources are defined in kismet.conf or on the
command line.  Please read the README for more information about
configuring Kismet.
Kismet exiting.
Done.

I followed this guide http://www.ubuntugeek.com/kismet-an-802-11-wireless-network-detector-sniffer-and-intrusion-detection-system.html#more-1776

how ever in kismet.conf I am not clear with following line

source=none,none,addme

as to what should I change this to.

lspci -vnn shows

0c:00.0 Network controller [0280]: Broadcom Corporation BCM4312 802.11b/g [14e4:4315] (rev 01)
    Subsystem: Dell Device [1028:000c]
    Flags: bus master, fast devsel, latency 0, IRQ 17
    Memory at f69fc000 (64-bit, non-prefetchable) [size=16K]
    Capabilities: [40] Power Management version 3
    Capabilities: [58] Vendor Specific Information <?>
    Capabilities: [e8] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable-
    Capabilities: [d0] Express Endpoint, MSI 00
    Capabilities: [100] Advanced Error Reporting <?>
    Capabilities: [13c] Virtual Channel <?>
    Capabilities: [160] Device Serial Number 
    Capabilities: [16c] Power Budgeting <?>
    Kernel driver in use: wl
    Kernel modules: wl, ssb

and

iwconfig shows

lo        no wireless extensions.

eth0      no wireless extensions.

eth1      IEEE 802.11bg  ESSID:"WIKUCD"  
          Mode:Managed  Frequency:2.462 GHz  Access Point: <00:43:92:21:H5:09>
          Bit Rate=11 Mb/s   Tx-Power:24 dBm   
          Retry min limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Managementmode:All packets received
          Link Quality=1/5  Signal level=-81 dBm  Noise level=-90 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:169  Invalid misc:0   Missed beacon:0

So what should I be putting in place of

 source=none,none,addme

with output I mentioned above ?